Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Fri Apr 19, 2024 6:25 pm


Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
dagizil
 Post subject: Question about ic chips
PostPosted: Fri May 22, 2015 10:44 am 

Joined: Tue May 19, 2015 11:58 am
Posts: 11
Do the legs have to be attached to be considered ic chips or can I cut them off to get them off the board. Thank you in advance for your help.
Top
 Profile  
 
kgryczan
PostPosted: Fri May 22, 2015 11:10 am 
Reputable Seller

Joined: Fri Jan 31, 2014 10:22 am
Posts: 796
I would imagine that the legs would need to be intact. If one or two are missing off the chip, you may be OK, but more than that, then you may not be able to sell the chip. Gold legs would need to be present to get the 8086 grade, otherwise, you will be selling them as regular IC chips.

_________________
kgryczan
Forum Moderator
Top
 Profile  
 
lostinlodos
PostPosted: Fri May 22, 2015 11:31 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9761
Location: Low DOS
I've been sending black ic chips sliced.(no legs) from low grade boards without issue so i take it it's the chip theyre after more than Tin/silver pins.
Just don't crack the actual ic.
This only applies to the non processor ics though.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: