Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Wed Apr 24, 2024 12:29 pm


Post new topic Reply to topic  Page 1 of 1
  [ 6 posts ] 
  Previous topic | Next topic 
Author Message
escrap16
 Post subject: board id please
PostPosted: Fri Dec 04, 2015 11:17 am 

Joined: Wed Jun 17, 2015 9:57 am
Posts: 43
Location: South Plainfield nj
Hi I'm able to place most parts in the right category. I'm a little stuck where these go.


Attachments:
File comment: what category would these boards go in.
20151203_144901.jpg
20151203_144901.jpg [ 1.68 MiB | Viewed 3800 times ]
File comment: how do I price this on board sort. What category ?
20151203_144827.jpg
20151203_144827.jpg [ 1.49 MiB | Viewed 3800 times ]
File comment: is this a processing card? or a finger card?
20151203_144847.jpg
20151203_144847.jpg [ 1.36 MiB | Viewed 3800 times ]
File comment: would go in the finger cards section?
20151203_144805.jpg
20151203_144805.jpg [ 1.55 MiB | Viewed 3800 times ]
Top
 Profile  
 
lostinlodos
 Post subject: Re: board id please
PostPosted: Sat Dec 05, 2015 12:48 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9764
Location: Low DOS
Dual large socket
Slot processor (remove the plastic)
Slot blank. Will be finger card or telco
Gold finger card
Top
 Profile  
 
escrap16
 Post subject: Re: board id please
PostPosted: Sat Dec 05, 2015 2:20 pm 

Joined: Wed Jun 17, 2015 9:57 am
Posts: 43
Location: South Plainfield nj
thank you for your reply. I appreciate your help. Its great.
Top
 Profile  
 
escrap16
PostPosted: Sun Dec 06, 2015 9:54 am 

Joined: Wed Jun 17, 2015 9:57 am
Posts: 43
Location: South Plainfield nj
For the slot boards does it matter if I take the plastic off to ship it better?

What about the heat sinks? does it change the price of I take those off?
Top
 Profile  
 
lostinlodos
 Post subject: Re: board id please
PostPosted: Sun Dec 06, 2015 12:39 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9764
Location: Low DOS
Yes. Slot processors must be free of heatsinks and plastic covers
Top
 Profile  
 
escrap16
 Post subject: Re: board id please
PostPosted: Sun Dec 06, 2015 3:08 pm 

Joined: Wed Jun 17, 2015 9:57 am
Posts: 43
Location: South Plainfield nj
thank you.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 6 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: