Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Fri Apr 19, 2024 1:09 pm


Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
602bridgeway
PostPosted: Sat Dec 12, 2015 6:28 pm 

Joined: Mon Apr 14, 2014 12:41 pm
Posts: 558
Not many components on the board but has gold fingers.

Thx


Attachments:
1449959269573.jpg
1449959269573.jpg [ 1.63 MiB | Viewed 1921 times ]
Top
 Profile  
 
lostinlodos
PostPosted: Sun Dec 13, 2015 12:55 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9761
Location: Low DOS
Definition of poor design in servers.

Unfortunately its peripheral.
If you cut the fingers off it will go midgrade but most times it's better fingers separate on ones like this.
Depending on exact weights i can't give you you're probably looking at about $2.20-2.50 board in tact and $3.00-3.50 mid + fingers
You can cut half of one finger off and weigh it to deduce actual finger weight without docking the board value.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

cron