Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 6:07 am


Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Question
PostPosted: Fri May 03, 2019 1:38 am 

Joined: Mon Apr 14, 2014 12:41 pm
Posts: 558
What would this qualify for?

If I remove the gold plated finger part, what does that go for as being only one sided gold plated fingers?

If I remove the excess plastic to where I only keep the area where the gold dots are, what would that go for alone?


Attachments:
A5171184-0B33-4F50-98FA-B5706F32ED18.jpeg
A5171184-0B33-4F50-98FA-B5706F32ED18.jpeg [ 3.16 MiB | Viewed 2198 times ]
Top
 Profile  
 
 Post subject: Re: Question
PostPosted: Fri May 03, 2019 2:04 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
Whole it’s mixed wire.
So trim the gold end off and put it in with your gold fingers.
The wire is still mixed wire.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
 Post subject: Re: Question
PostPosted: Fri May 03, 2019 2:06 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
If you trim the contact ‘dozs’ Extremely close you can place the dot strips in gold finger as well. That’s what I normally do.


Attachments:
177C6F8D-58AC-40EB-A9D7-018F68EF4B59.jpeg
177C6F8D-58AC-40EB-A9D7-018F68EF4B59.jpeg [ 790.9 KiB | Viewed 2195 times ]

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: