Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Fri Apr 19, 2024 7:10 am


Post new topic Reply to topic  Page 1 of 1
  [ 4 posts ] 
  Previous topic | Next topic 
Author Message
flippy
PostPosted: Mon Jan 11, 2016 1:58 am 

Joined: Sat Jun 07, 2014 7:29 am
Posts: 40
I recently had the valvebody circuit board replaced in my Mercedes. I was wondering what category it would go under, if Boardsort is interested at all?


Attachments:
IMG_0371.jpg
IMG_0371.jpg [ 1.07 MiB | Viewed 3830 times ]
Top
 Profile  
 
lostinlodos
PostPosted: Mon Jan 11, 2016 7:16 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9761
Location: Low DOS
Flip it over. Looks like a bunch of plastic in this pic
Top
 Profile  
 
flippy
PostPosted: Mon Jan 11, 2016 9:04 am 

Joined: Sat Jun 07, 2014 7:29 am
Posts: 40
There is even less visible on the other side. I was mainly hoping someone had experience with similar boards from a car and could advise based upon that.

I might try to break open the plastic to see if there in an actual board underneath or if it is just mainly plastic with some embedded copper.


Attachments:
IMG_2642.jpg
IMG_2642.jpg [ 1.21 MiB | Viewed 3815 times ]
Top
 Profile  
 
lostinlodos
PostPosted: Mon Jan 11, 2016 3:47 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9761
Location: Low DOS
It looks like a bunch of silver plated relays.
My suggestion is to take it to a large recycler and try to get cbm rate for it as is.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 4 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: