All of the boards below are out of Dell servers. In the pictures on top at the bottom of the picture there is a skinny board and I was wondering if I could cut the fingers off without downgrading it.
Thank you!
Attachments: |
20190826_165143.jpg [ 2.25 MiB | Viewed 1289 times ]
|
20190826_165038.jpg [ 2.38 MiB | Viewed 1289 times ]
|
20190826_164857.jpg [ 2.09 MiB | Viewed 1289 times ]
|
20190826_164805.jpg [ 2.57 MiB | Viewed 1289 times ]
|
20190826_164622.jpg [ 2.03 MiB | Viewed 1289 times ]
|
20190826_164551.jpg [ 2.37 MiB | Viewed 1289 times ]
|
20190826_164348.jpg [ 2.1 MiB | Viewed 1289 times ]
|
20190826_164312.jpg [ 2.24 MiB | Viewed 1289 times ]
|