Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Fri Mar 29, 2024 4:36 am


Post new topic Reply to topic  [ 6 posts ] 
Author Message
 Post subject: Id help please
PostPosted: Wed May 27, 2020 5:01 pm 

Joined: Mon Mar 12, 2018 6:17 pm
Posts: 48
I have several hundred of these. Let me tell you they are a pain to get apart. Hoping good enough to make it worth the effort. Lol


Attachments:
File comment: Back
15906131302621653311524156246551.jpg
15906131302621653311524156246551.jpg [ 3.87 MiB | Viewed 2133 times ]
15906130414157329579349274734449.jpg
15906130414157329579349274734449.jpg [ 4.97 MiB | Viewed 2133 times ]
Top
 Profile  
 
 Post subject: Re: Id help please
PostPosted: Wed May 27, 2020 5:10 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9752
Location: Low DOS
High telco.
Removing the epoxy doesn’t make the chip a gold cap. It’s just a capless flat pack.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
 Post subject: Re: Id help please
PostPosted: Wed May 27, 2020 6:13 pm 

Joined: Mon Mar 12, 2018 6:17 pm
Posts: 48
Yeah I didn't think removing cap would help. That one just came off with the heat sink.


Top
 Profile  
 
 Post subject: Re: Id help please
PostPosted: Wed May 27, 2020 6:30 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9752
Location: Low DOS
I figured. Was just pointing it out for the inevitable ‘why not gold cap’ question to come from someone.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
 Post subject: Re: Id help please
PostPosted: Wed May 27, 2020 6:45 pm 

Joined: Mon Mar 12, 2018 6:17 pm
Posts: 48
Actually I am more grateful it won't make it better. I would never get another off. I just happy they are better than pref, I would probably just left the steel back on them and snuck a few in here or there with my steel.

One question, should or do I need to pull the fuses?


Top
 Profile  
 
 Post subject: Re: Id help please
PostPosted: Wed May 27, 2020 7:40 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9752
Location: Low DOS
You should. They are glass and tend to break into sharp jagged tools.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 6 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: