Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Sat Apr 27, 2024 12:41 pm


Post new topic Reply to topic  Page 1 of 1
  [ 5 posts ] 
  Previous topic | Next topic 
Author Message
scrapperfern
PostPosted: Sat Mar 16, 2024 3:47 pm 

Joined: Sun Jan 14, 2024 6:13 pm
Posts: 1
Hello all. I completely understand the policy of the lower rate for contemporary SATA board versus IDE/ SCSI logic boards. However, I have some very early generation SATA boards that seem to be highly populated and was wondering if they would still go as low grade SATA? Any help would be greatly appreciated. Thank you.


Attachments:
20240316_124532.jpg
20240316_124532.jpg [ 2.06 MiB | Viewed 832 times ]
20240316_124523.jpg
20240316_124523.jpg [ 2.06 MiB | Viewed 832 times ]
20240316_124521.jpg
20240316_124521.jpg [ 1.97 MiB | Viewed 832 times ]
20240316_124518.jpg
20240316_124518.jpg [ 1.66 MiB | Viewed 832 times ]
Top
 Profile  
 
ropeman
PostPosted: Sun Mar 17, 2024 10:11 pm 

Joined: Tue May 14, 2019 11:09 am
Posts: 498
You could send an email to Boardsort, but the class is what it is. Some SATA boards might be the same as IDE boards but they have to make the decision to have a cutoff somewhere.
Top
 Profile  
 
ButtersMed
PostPosted: Sun Mar 31, 2024 11:49 pm 

Joined: Tue Dec 05, 2023 2:28 am
Posts: 1
Did you get an answer on how to sort these? I've had a bunch of serial-attached SCSI boards from old servers, and wondered the same thing.
Top
 Profile  
 
Mwfhawk
PostPosted: Mon Apr 01, 2024 11:15 am 

Joined: Thu Aug 13, 2015 10:53 pm
Posts: 109
Any hard drive board that does not have sata connector is high grade. Any hard drive board with a sata connector is low grade.
Top
 Profile  
 
PickleJar
PostPosted: Sun Apr 07, 2024 4:02 pm 

Joined: Thu Feb 04, 2021 2:53 am
Posts: 395
I previously emailed Chris about this. For now, all SATA boards are low grade regardless. Even if they are SSDs that are covered with memory chips on both sides.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 5 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

cron