Boardsort.com

Your complete E-scrap resource website. LEARN - SELL - PROFIT
It is currently Sat Jun 24, 2017 6:19 am


Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Sas drive tear down
PostPosted: Tue Mar 21, 2017 3:17 pm 

Joined: Tue Mar 21, 2017 3:03 pm
Posts: 1
Hey guys bit of a newb to drive tear downs but I've done a few older SCSI drives and ide/sata drives. My first time opening a 2.5 sas drive and I found this little board attached to ribbon on the actuator arm.

What would be the best way to handle the small board. Haven't seen any of these on eBay or what term I should even search for. Looks like a decent amount of gold plate.
Thanks


Attachments:
IMG_3105.JPG
IMG_3105.JPG [ 1.45 MiB | Viewed 209 times ]
Top
 Profile  
 
 Post subject: Re: Sas drive tear down
PostPosted: Tue Mar 21, 2017 4:56 pm 

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 3063
Location: Low DOS
There's actually not all that much there. It's thinner gold than in gold laminate.
If it has an IC chip on it I toss them in peripheral.
If not I'll peel it off the base; you probably put it in wire once you remove the aluminium.

_________________
-- my grades are my own and do not represent an offer from boardsort, nor are they guaranteed. Please keep that in mind.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: