Welcome to Boardsortâ„¢ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Tue Mar 19, 2024 3:55 am


Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Sas drive tear down
PostPosted: Tue Mar 21, 2017 3:17 pm 

Joined: Tue Mar 21, 2017 3:03 pm
Posts: 1
Hey guys bit of a newb to drive tear downs but I've done a few older SCSI drives and ide/sata drives. My first time opening a 2.5 sas drive and I found this little board attached to ribbon on the actuator arm.

What would be the best way to handle the small board. Haven't seen any of these on eBay or what term I should even search for. Looks like a decent amount of gold plate.
Thanks


Attachments:
IMG_3105.JPG
IMG_3105.JPG [ 1.45 MiB | Viewed 2677 times ]
Top
 Profile  
 
 Post subject: Re: Sas drive tear down
PostPosted: Tue Mar 21, 2017 4:56 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9748
Location: Low DOS
There's actually not all that much there. It's thinner gold than in gold laminate.
If it has an IC chip on it I toss them in peripheral.
If not I'll peel it off the base; you probably put it in wire once you remove the aluminium.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

cron