Welcome to Boardsortâ„¢ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 6:07 am


Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: Need Help Identifying
PostPosted: Wed Jul 05, 2017 5:07 pm 

Joined: Sat Apr 30, 2016 4:41 pm
Posts: 27
Could use some help identifying these? On the Power Supply Board, I would normally put it as mid-grade but it had the gold slide in. I have serveral of these Server Power Supplies. Am I better to trim off the Gold End and then put it in low grade or mid grade.

Thanks


Attachments:
File comment: Thick Multi Proc Board?
Thick Multi.jpg
Thick Multi.jpg [ 1.7 MiB | Viewed 2248 times ]
File comment: The 1 board is out of a PBX. The other is a RAM Expansion Board
Telecom & Ram.jpg
Telecom & Ram.jpg [ 1.85 MiB | Viewed 2248 times ]
File comment: Network Switch Boards
Switch2.jpg
Switch2.jpg [ 1.5 MiB | Viewed 2248 times ]
File comment: Network Switch Boards
Network Switch.jpg
Network Switch.jpg [ 1.29 MiB | Viewed 2248 times ]
File comment: Back Plane Boards with Gold Fingers
Back1.jpg
Back1.jpg [ 1.48 MiB | Viewed 2248 times ]
File comment: Wireless AP Boards & Power Supply Board with Gold End.
AP and PS.jpg
AP and PS.jpg [ 1.28 MiB | Viewed 2248 times ]
Top
 Profile  
 
PostPosted: Wed Jul 05, 2017 6:10 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
Depends on the back side. But it needs bus support to be a motherboard. It's missing card and ram sockets, and the related IC chips. I'd say this falls into peripheral


The two ram boards are backplane. The third is probably peripheral


Think both clear telco


Peripheral on the left telco on the right


The large one is backplane the sell is gold finger card the one next to it (HP?) is
Peripheral with or without the fingers and the smallest one is peripheral as is. If you cut the finger it will be gold pin connector.


The power board will be midgrade no matter what you do. If you cut the gold fingers you'll get mid grade and gold fingers. Cut further back and get the nickel flashing blank with it and you'll have peripheral and a trimmed midgrade power supply. Hop you can follow that. :)
The other 3 are peripheral. Remove the heat sink and shields. And the wires. Those wires are usually silver/nickel btw.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: