Boardsort.com

Your complete E-scrap resource website. LEARN - SELL - PROFIT
It is currently Wed Aug 22, 2018 4:14 am


Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sun Feb 11, 2018 2:42 pm 

Joined: Thu Jun 29, 2017 10:47 pm
Posts: 54
Have some small boards and cable ends to ID


Attachments:
20180211_113946.jpg
20180211_113946.jpg [ 3.05 MiB | Viewed 432 times ]
Top
 Profile  
 
PostPosted: Sun Feb 11, 2018 5:15 pm 

Joined: Fri Sep 25, 2015 5:43 pm
Posts: 29
Two of the boards (both are laptop trackpad boards) are probably peripheral. The laptop mouse button board is probably midgrade. The item below these boards is a PCIe x16 riser cable. I am not sure of the category into which the cable goes, but you can at least trim the gold fingers.


Top
 Profile  
 
PostPosted: Sun Feb 11, 2018 5:24 pm 

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 4427
Location: Low DOS
Sam has it.

Cut the finger end off the wire. That will get clean gold fingers.cut the socket nd off the other side. That gets gold pin connector.
Finally boardsort buys the remaining cable as mixed wire. Or locally you’d get low grade insulated wire, or harness wire.

_________________
-- my grades are my own and do not represent an offer from boardsort, nor are they guaranteed. Please keep that in mind.


Top
 Profile  
 
PostPosted: Sun Feb 11, 2018 8:11 pm 

Joined: Thu Jun 29, 2017 10:47 pm
Posts: 54
Thanks much guys.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: