Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 2:58 pm


Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Tue Jul 17, 2018 1:54 pm 

Joined: Sun May 17, 2015 4:17 pm
Posts: 113
Location: Md Eastern Shore
On mid range boards is it ok to leave wires with ends attached to the boards since mixed wire is higher in scrap value than mid range. I know I should cut wires off but I was feeling lazy when I was sorting for my load. Actually I was tired of sorting, finally boxing my twelve years of scrap for a run though most was presorted but was double checking to lessen my mistakes maybe.


Top
 Profile  
 
PostPosted: Wed Jul 18, 2018 5:03 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
Leaving small bits here and there, especially attached to ends, isn’t really a problem. Leaving power and ribbon cables attatched and intact is a big no-no and will get docked at some level.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
PostPosted: Wed Jul 18, 2018 2:13 pm 

Joined: Sun May 17, 2015 4:17 pm
Posts: 113
Location: Md Eastern Shore
thank you .


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: