I'm fairly certain the vast majority of these PCBDs are Gold Finger class.
I do, however, have a question regarding a few of them.
In addition to the gold fingers, there are gold pins.
Is it wise to clip the gold pins? If the gold pins are clipped, does it drop the grade of the board?
What would you recommend?
Thank you,
RustyFuryIII
Attachments: |
IMG_8390.JPG [ 1.97 MiB | Viewed 1503 times ]
|
IMG_8389.JPG [ 1.61 MiB | Viewed 1503 times ]
|
File comment: Can I cut the gold pins w/o dropping grade of board? Is it wise to do so?
IMG_8388.JPG [ 1.82 MiB | Viewed 1503 times ]
|
File comment: Do I remove the transducer/speaker?
IMG_8387.JPG [ 2.6 MiB | Viewed 1503 times ]
|
IMG_8386.JPG [ 1.71 MiB | Viewed 1503 times ]
|
IMG_8385.JPG [ 1.95 MiB | Viewed 1503 times ]
|
IMG_8383.JPG [ 2.2 MiB | Viewed 1503 times ]
|
IMG_8384.JPG [ 1.77 MiB | Viewed 1503 times ]
|
IMG_8382.JPG [ 2.58 MiB | Viewed 1503 times ]
|
IMG_8381.JPG [ 2.45 MiB | Viewed 1503 times ]
|
IMG_8380.JPG [ 2.44 MiB | Viewed 1503 times ]
|
IMG_8379.JPG [ 2.48 MiB | Viewed 1503 times ]
|
IMG_8378.JPG [ 2.36 MiB | Viewed 1503 times ]
|
IMG_8377.JPG [ 1.98 MiB | Viewed 1503 times ]
|
IMG_8376.JPG [ 1.73 MiB | Viewed 1503 times ]
|