Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 5:06 am


Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sun Feb 11, 2018 2:42 pm 

Joined: Thu Jun 29, 2017 10:47 pm
Posts: 280
Have some small boards and cable ends to ID


Attachments:
20180211_113946.jpg
20180211_113946.jpg [ 3.05 MiB | Viewed 2422 times ]
Top
 Profile  
 
PostPosted: Sun Feb 11, 2018 5:15 pm 

Joined: Fri Sep 25, 2015 5:43 pm
Posts: 30
Two of the boards (both are laptop trackpad boards) are probably peripheral. The laptop mouse button board is probably midgrade. The item below these boards is a PCIe x16 riser cable. I am not sure of the category into which the cable goes, but you can at least trim the gold fingers.


Top
 Profile  
 
PostPosted: Sun Feb 11, 2018 5:24 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
Sam has it.

Cut the finger end off the wire. That will get clean gold fingers.cut the socket nd off the other side. That gets gold pin connector.
Finally boardsort buys the remaining cable as mixed wire. Or locally you’d get low grade insulated wire, or harness wire.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
PostPosted: Sun Feb 11, 2018 8:11 pm 

Joined: Thu Jun 29, 2017 10:47 pm
Posts: 280
Thanks much guys.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

cron