Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Apr 18, 2024 12:51 pm


Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
rdw1121
 Post subject: Any suggestions
PostPosted: Thu Jul 22, 2021 10:32 pm 

Joined: Fri Jul 01, 2016 6:55 pm
Posts: 742
Location: Texas
Third board:
These are front and back of identical boards.
I cant quite tell if the silver colored cap is part of the chip underneath it but it is soldered to the board. I cant slid a screw driver under it to pry it off.

Second board:
Can I snip the gold wire (antenna) and pull the charging contacts with out down grading the board?

First board:
I am pulling these charging pins do I need to try and get the springs out?


Attachments:
92ACBE79-FE8D-4819-90A6-1D66539225E9.jpeg
92ACBE79-FE8D-4819-90A6-1D66539225E9.jpeg [ 2.17 MiB | Viewed 1330 times ]
BA7D4DB8-E827-4FC7-AC07-2F81CC854F69.jpeg
BA7D4DB8-E827-4FC7-AC07-2F81CC854F69.jpeg [ 2.28 MiB | Viewed 1330 times ]
AC789873-95DD-4E3E-A776-6D50089ACEF2.jpeg
AC789873-95DD-4E3E-A776-6D50089ACEF2.jpeg [ 2.19 MiB | Viewed 1330 times ]
Top
 Profile  
 
rdw1121
 Post subject: Re: Any suggestions
PostPosted: Fri Jul 23, 2021 9:47 pm 

Joined: Fri Jul 01, 2016 6:55 pm
Posts: 742
Location: Texas
I went ahead and pulled the antenna wire and the antenna jacks on the second boards. I still cant figure out what to do with those silver colored caps(they are magnetic).
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: