Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Apr 18, 2024 7:24 am


Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
jnwaite
PostPosted: Thu Sep 30, 2021 7:58 pm 

Joined: Tue Mar 20, 2018 8:30 pm
Posts: 34
So, as careful as I am, every so often a soldered chip / flatpack pulls off the board when I'm removing a glued-on heat sink (or worse, a gold-cap chip!). What is the correct protocol to avoid having the board downgraded? Do I need to re-attach it somehow? Do I just include it loose with the the board? Or does the removed component have to be sold separately?

Thanks!
Top
 Profile  
 
PickleJar
PostPosted: Thu Sep 30, 2021 8:05 pm 

Joined: Thu Feb 04, 2021 2:53 am
Posts: 395
Based on reading other forum posts, it should be fine if you tape the chip back on with clear tape
Top
 Profile  
 
jnwaite
PostPosted: Thu Sep 30, 2021 8:11 pm 

Joined: Tue Mar 20, 2018 8:30 pm
Posts: 34
They're on there with tape now, but I was thinking maybe a small drop of hot glue would be better.
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: