Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Sat Sep 30, 2023 9:15 am


Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
MRJolly75
PostPosted: Thu Jul 21, 2022 10:46 pm 

Joined: Wed Feb 07, 2018 5:46 pm
Posts: 6
I have seen this thermal silcone gel coating on sone auto boards in my time turning wrenches and recently found one in a dryer.
The gel is rather pungent and difficult to remove. Should i even bother sending it with my shipment to boardsort? And if so, should i even attempt to remove the silicone or will it get accepted regardless?
Top
 Profile  
 
MRJolly75
PostPosted: Thu Jul 21, 2022 10:50 pm 

Joined: Wed Feb 07, 2018 5:46 pm
Posts: 6
Three millimeter thick layer of thermal silicone coating the entire board.


Attachments:
20220721_214749.jpg
20220721_214749.jpg [ 3.41 MiB | Viewed 896 times ]
Top
 Profile  
 
lostinlodos
PostPosted: Thu Jul 21, 2022 11:10 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9665
Location: Low DOS
The boards go as the same class with or without the sealant coating

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to:  

cron