Welcome to Boardsortâ„¢ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Mon Mar 23, 2026 6:24 pm

All times are UTC - 5 hours [ DST ]




Post new topic Reply to topic  [ 4 posts ] 
Author Message
PostPosted: Sat Mar 21, 2026 1:14 pm 
User avatar

Joined: Mon Apr 15, 2024 9:38 pm
Posts: 365
Location: Western Pennsylvania
I came across about 60 shielded Gold Fingered Ram. Note. I keep the hot air gun on. And use it 95% of the time. Some shields will fall off after removing supporting clips. But. Not always. Of course. There is a myriad of "substances" used to "secure" contact between the heat sink and the ram. The glue. The glue strip. Etc. Remains on the ram board. It is close to stupid to try and remove it. Am I ok. Just submitting Gold Finger Ram with that residue?
Here to learn like everybody else


Top
 Profile  
Reply with quote  
PostPosted: Sat Mar 21, 2026 3:05 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10223
Location: Low DOS
As long as all reasonable attempt was made to clean it yes.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
Reply with quote  
PostPosted: Mon Mar 23, 2026 11:45 am 
User avatar

Joined: Mon Apr 15, 2024 9:38 pm
Posts: 365
Location: Western Pennsylvania
Removing the glue and thermal compound from Gold Finger Ram was not exactly quick and easy. I would call the process tedious and time consuming. I used a basic utility knife. Basically just scraping. The adhesive balled up and stuck terribly to the blade and board. But. I feel good about having reasonably removed the contaminents. Thanks Lostinlodos. But I have not seen a post exclusively addressing the subject of removing shields from Gold Finger Ram. EXCEPT. Addressing the issue of removing shields to reap more money. After all. There's quite a difference in price between Shielded and Unshielded. Which dovetails into my original interest in even considering removing shields from Gold Finger Ram. WHEN DOES IT PAY TO REMOVE SHIELDS? I did a calculation of average weight of clean Gold Finger Ram. Versus average weight of Shielded Gold Finger Ram. To those with some math knowledge. THE MEAN weights overall. I did my novice calculation with Gold Finger Ram at $60 a pound. Shielded at $22 a pound. My conclusion. At a Shielded Gold Finger Ram weighing 2.0 oz. or above please do submit to Boardsort. The payout will be greater than removing the shielding. This type of calculation is directly parallel with Gold Finger Card with bracket versus Gold Finger Card clean. A payout issue that is real. But. It is fluid. Prices change. After the downward swing of prices. You should do your own judgement.
NOTE. I am in full retirement. I have time to fiddle with this type of issue.
Here to learn like everybody else
My evaluations are my own.


Top
 Profile  
Reply with quote  
PostPosted: Mon Mar 23, 2026 11:46 am 
User avatar

Joined: Mon Apr 15, 2024 9:38 pm
Posts: 365
Location: Western Pennsylvania
Removing


Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: