Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Fri May 01, 2026 1:30 am

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
716scrap
 Post subject: Lostinlodos job security
PostPosted: Thu Apr 09, 2020 3:54 pm 

Joined: Tue Apr 07, 2020 3:09 pm
Posts: 48
Going to keep you busy for at least one more day with id questions. Think I’m getting it just want to be sure


You do not have the required permissions to view the files attached to this post.

Top
 Profile  
Reply with quote  
lostinlodos
PostPosted: Thu Apr 09, 2020 4:56 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10335
Location: Low DOS
Both peripheral

Small one is a terminator of sorts. Peripheral
Yes remove fan/heatsink for GFC

Both peripheral. Don’t trim the fingers, not much to this board.

Gfc with fan or heatsink. I know... it’s where it is.

CU/AL and touch pads go as peripheral.

Take the drive out of the shell and it will be hard drive board. Same idea with the PCMCIA card. Pop it out. Most range from peripheral to high telco. This one I believe will be high telco.

Peripheral and the airport will be high telco out of the case. Leave the case on for low grade gold finger card with fan or heatsink.

Midgrade and gold pin connector

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: