Welcome to Boardsortâ„¢ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 6:53 pm


Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: ID Help Please
PostPosted: Wed Nov 10, 2021 4:02 pm 

Joined: Mon Mar 07, 2016 2:25 am
Posts: 15
Hello,

I need help in ID the following boards. Should I try and remove the mesh cover on the back of #5?

Photos of front and back.

Thanks in advance!


Attachments:
20211110_134451.jpg
20211110_134451.jpg [ 2.23 MiB | Viewed 849 times ]
20211110_134529.jpg
20211110_134529.jpg [ 2.27 MiB | Viewed 849 times ]
Top
 Profile  
 
 Post subject: Re: ID Help Please
PostPosted: Wed Nov 10, 2021 6:51 pm 

Joined: Sat Nov 29, 2014 9:44 pm
Posts: 1138
Location: I'm right here :D
1) Hard Drive board
2) slot processor
3,4) trackpads are almost always high peripheral
5) that looks like some sort of tape that should peel off. If the metal under it completely covers the board it should be removed, if there's openings in the metal you can probably leave it on (take another pic after the tape is off if your not sure) clean gold finger card if the metal is all off.
6) Not 100% sure low peripheral at least.

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort


Top
 Profile  
 
 Post subject: Re: ID Help Please
PostPosted: Wed Nov 10, 2021 7:46 pm 

Joined: Mon Mar 07, 2016 2:25 am
Posts: 15
Thank you for the help marked!!


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: