Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Tue Jun 04, 2024 11:20 pm


Post new topic Reply to topic  Page 1 of 1
  [ 5 posts ] 
  Previous topic | Next topic 
Author Message
frank41476
 Post subject: more help please
PostPosted: Sat Feb 27, 2016 12:42 pm 

Joined: Mon Mar 24, 2014 3:22 pm
Posts: 14
I cut the fingers off of these so I am wondering if any of them are better than trimmed finger cards


Attachments:
IMG_0945.JPG
IMG_0945.JPG [ 2.99 MiB | Viewed 3734 times ]
IMG_0944.JPG
IMG_0944.JPG [ 3.01 MiB | Viewed 3734 times ]
IMG_0943.JPG
IMG_0943.JPG [ 2.77 MiB | Viewed 3734 times ]
IMG_0942.JPG
IMG_0942.JPG [ 2.59 MiB | Viewed 3734 times ]
IMG_0941.JPG
IMG_0941.JPG [ 2.95 MiB | Viewed 3734 times ]
IMG_0940.JPG
IMG_0940.JPG [ 2.69 MiB | Viewed 3734 times ]
IMG_0937.JPG
IMG_0937.JPG [ 1.51 MiB | Viewed 3734 times ]
Top
 Profile  
 
lostinlodos
 Post subject: Re: more help please
PostPosted: Sat Feb 27, 2016 2:21 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9786
Location: Low DOS
0945 top board should clear telco
0944 all peripheral
0943 top is telco bottom one could.clear telco
0942 middle is small socket, right telco
0941 all peripheral
0940 all peripheral
0937:
Gold finger card
Telco
Gold finger card
Top
 Profile  
 
frank41476
 Post subject: Re: more help please
PostPosted: Sat Feb 27, 2016 2:50 pm 

Joined: Mon Mar 24, 2014 3:22 pm
Posts: 14
the one you classified as small socket is 1 3/4 inches wide doesn't that make it large socket.
Top
 Profile  
 
lostinlodos
 Post subject: Re: more help please
PostPosted: Sat Feb 27, 2016 4:58 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9786
Location: Low DOS
It would if it was a full board but this is a breakout board. It's missing all the external ports.
Normally I would batch these type boards along with the soldered socket motherboards; which also go small socket despite cpu size.
Top
 Profile  
 
frank41476
 Post subject: Re: more help please
PostPosted: Sat Feb 27, 2016 9:21 pm 

Joined: Mon Mar 24, 2014 3:22 pm
Posts: 14
Thanks for the input
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 5 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: