Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 10:27 am


Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Thu Sep 16, 2021 10:32 pm 

Joined: Wed Sep 01, 2021 11:18 pm
Posts: 4
Hello,
I am trying to see if it makes sense to try depopulating these boards or just sending them in as is. The faceplates are riveted on and don't seem easy to remove. Also not certain what else I would need to remove to get high telecom grade. Any tips would be appreciated.
Thanks!


Attachments:
IMG-7545.jpg
IMG-7545.jpg [ 2.91 MiB | Viewed 2690 times ]
IMG-7546.jpg
IMG-7546.jpg [ 3.15 MiB | Viewed 2690 times ]
Top
 Profile  
 
PostPosted: Thu Sep 16, 2021 11:25 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
Tip for this kind of setup.

1/10” carbide or titanium drill bit.

Drill through the rivet and then use a size 1 or larger standard (flat
Head) screwdriver to pop it loose.

Takes a bit of practice to get the slight angle that makes the removing part easy but only takes a few seconds.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
PostPosted: Fri Sep 17, 2021 8:26 am 

Joined: Wed Sep 01, 2021 11:18 pm
Posts: 4
Thanks - I will give it a shot.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: