Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Tue Apr 23, 2024 7:28 pm


Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 
  Previous topic | Next topic 
Author Message
Guise2943
PostPosted: Sun Feb 26, 2023 3:17 pm 

Joined: Sun Feb 26, 2023 12:56 pm
Posts: 6
Hi! I'm new to scrapping so just want to make sure I do this right.

It might be tough to tell but the thing on the right hand side is a flappy ribbon thing. Should I cut if off? If so, should I send it separately? What would it be?

Do the wire ends attached to the chip seem okay or should I cut them further?

Should I remove the stickers?

Thank you in advance!


Attachments:
IMG_5363.JPG
IMG_5363.JPG [ 361.57 KiB | Viewed 6266 times ]
IMG_5364.JPG
IMG_5364.JPG [ 1.81 MiB | Viewed 6266 times ]
Top
 Profile  
 
lostinlodos
PostPosted: Sun Feb 26, 2023 3:56 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9764
Location: Low DOS
When they’re attached to glass, cut them off for some reason they tend to take a few shards of glass with them
Anything else just gently rip it off. They go as wire.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
 
Guise2943
PostPosted: Sun Feb 26, 2023 7:55 pm 

Joined: Sun Feb 26, 2023 12:56 pm
Posts: 6
lostinlodos wrote:
When they’re attached to glass, cut them off for some reason they tend to take a few shards of glass with them
Anything else just gently rip it off. They go as wire.


Thanks!
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 3 posts ] 

Board index » How to's, Tips & Techniques

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: