Welcome to Boardsortâ„¢ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Thu Mar 28, 2024 11:13 am


Post new topic Reply to topic  [ 4 posts ] 
Author Message
 Post subject: is it ok to...
PostPosted: Mon Nov 30, 2020 10:49 pm 

Joined: Sun Nov 08, 2020 12:26 am
Posts: 81
I don't have a lot of stuff and would like to use a flat rate box so if it is done to make a board fit in a box and not to remove material, could I cut this board in the marked locations. thanks


Attachments:
4 cut.jpg
4 cut.jpg [ 1.72 MiB | Viewed 2086 times ]
Top
 Profile  
 
 Post subject: Re: is it ok to...
PostPosted: Mon Nov 30, 2020 10:58 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
Cutting is fine if all pieces are included and together

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
 Post subject: Re: is it ok to...
PostPosted: Mon Nov 30, 2020 11:14 pm 

Joined: Sun Nov 08, 2020 12:26 am
Posts: 81
thanks lost. I was hoping that would be the answer.


Top
 Profile  
 
 Post subject: Re: is it ok to...
PostPosted: Tue Dec 01, 2020 1:34 am 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 9751
Location: Low DOS
As posted in the other thread you can cull the fingers here.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 4 posts ] 

All times are UTC - 5 hours [ DST ]


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: