Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Fri Aug 28, 2026 2:33 am

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
Fdsales1
 Post subject: To cut or not to cut
PostPosted: Thu Aug 27, 2026 3:18 pm 

Joined: Tue Jun 23, 2026 11:39 am
Posts: 4
Hello,

I have a bunch of these boards with metal plating that is very difficult to get off. There isn't a lot underneath the plate. Am I better off cutting the board as pictured and just sending the top portion in as peripheral or will I get docked sending the whole board in?

Thanks!
Robb


You do not have the required permissions to view the files attached to this post.

Top
 Profile  
Reply with quote  
lostinlodos
 Post subject: Re: To cut or not to cut
PostPosted: Thu Aug 27, 2026 5:45 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10527
Location: Low DOS
The plate on drops to midgrade.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: