Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Sun Sep 20, 2026 12:00 am

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 2 of 2
  [ 12 posts ]  Go to page Previous  1, 2
  Previous topic | Next topic 
Author Message
rdw1121
 Post subject: Re: Worth messing with?
PostPosted: Wed Nov 20, 2019 9:57 pm 

Joined: Fri Jul 01, 2016 6:55 pm
Posts: 750
Location: Texas
I was surprised it sold for so much, especially with the rough looking condition. The buyer had to know what that stuff was or they made a bad boo boo.
Top
 Profile  
Reply with quote  
lostinlodos
 Post subject: Re: Worth messing with?
PostPosted: Wed Nov 20, 2019 10:15 pm 
Site Admin
User avatar

Joined: Tue Feb 03, 2015 6:57 pm
Posts: 10563
Location: Low DOS
For a standard breakdown they’re looking at $20 if lucky.
I could probably go to the extreme and get around $50 out of it. At the point of pulling copper from transformers; etc.
Hopefully they know what they’re doing. But this is an auction case where I just shake my head. Not my money.

_________________
42 6F 61 72 64 73 6F 72 74 2E 63 6F 6D
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 2 of 2
  [ 12 posts ]  Go to page Previous  1, 2

Board index » E-Scrap Forum General Discussion

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: