Wondering what this boards would go as

1-2. Midgrade or low peripheral due to the aluminum heatsinks and fuses (assuming they're glass). Get the heatsinks/fuses off and you may be looking at high peripheral

3. Midgrade, I don't think there's any way around it

4. Low peripheral, too bad the gold fingers are cut off

5. Midgrade, possibly better but again the aluminum weight keeps the grade lower

6. High Telco, I think there's enough IC population along with the gold fingers (am I seeing more fingers on the back?)

7. Low Peripheral, there's a lot of empty board so I don't think it can go higher.

But I'm still learning and could be wrong so if ccussins or someone comes along and says otherwise, they're probably right.

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort

On board 1 I see 3 gold cap chips, they look really dirty and rust covered so they are hard to see in the picture. So that will have some effect on the grade.

Good catch, even after you said it I had trouble finding them.

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort

On board 3 them black boxes are extremely heavy so should I remove them

1) Still checking with Chris
2) Migrade
3) Midgrade
4) High Grade Peripheral
5) High Grade Peripheral if you remove the black heat sinks.
6) Still checking
7) Low Grade Peripheral

Chis says: