Welcome to Boardsort™ - Learn - Sell - Profit -

Learn to properly Sort, Sell, and Profit from your electronic scrap material.
It is currently Sat Mar 21, 2026 6:36 pm

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]



Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 
  Previous topic | Next topic 
Author Message
Corsair05
 Post subject: Sata HD connectors
PostPosted: Sat Mar 21, 2026 2:00 pm 

Joined: Fri Jan 16, 2015 1:01 am
Posts: 5
Hello everyone
If I were to cut the Sata connectors from a HD, would that be considered gold fingers?

Thanks in advance
Top
 Profile  
Reply with quote  
marked141
 Post subject: Re: Sata HD connectors
PostPosted: Sat Mar 21, 2026 6:12 pm 

Joined: Sat Nov 29, 2014 9:44 pm
Posts: 1877
Location: I'm right here :D
They'd be gold pins or gold connector end (if in the plastic) from the HDD. Better off unscrewing the torx (occasionally phillips) screws and selling the boards intact.

SATA wire ends likely have gold pins too and would be gold connector end if snipped off.

_________________
Here to learn more so I can recycle more
My grades are my own opinion and not an official grade from Boardsort
Top
 Profile  
Reply with quote  
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 1
  [ 2 posts ] 

Board index » What is it? Identification Forum

All times are UTC - 5 hours [ DST ]

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Jump to: